- D coiler 2 ton cap.
- Entry Gate with
- Roll Forming Machine with 12 station , 1 Gear Boxes & 10 H.P. electrical.
- Control Panel semi auto
- Cutting Unit (Hydro.)
Technical Specifications
- Maximum sheet width that can be formed : 1550mm
- Maximum sheet thickness in CRCA Strips that can be formed : 1 mm
- Horizontal distance between shafts : 400mm
- Number of forming stations : 12 nos
- Vertical station : 11 nos
- Total HP for Line : 13
- Speed of the machine : 7 mt./minute
- Size of machine : 6500 x 1100 x 1100 mm
Mandrel Uncoiler
- Coil weight : 2 MT Max
- Coil width : 1200 MM
- Coil bore : 450 MM min, 510 MM max dia.
- Mandrel movement : Manually adjusted
- Back Tension : Manually adjusted
Entry Gate
Entry gate will be provided for movement of sheet to roll former.
Main Base
The main base is MS fabricated structure and adequately ribbed
to minimize the distortion. It is accurately machined on top and bottom
surfaces the threaded holes are made on the bed for positioning the
stands.
Mill stands (Station)
The stands are mounted on the bed of the machine the line
alignment can be easily done due to guide ways arranged on the bed of
the machine. Each forming head consists of a fixed housing and sliding
type out board housing. The mill stands will be arranged to locate
shafts mounted on taper bearings. For the top shafts the bearings are
housed in the cartridge type bearing blocks. The bottom shaft bearings
are located in the bored machined in the housings. The bottom arbors are
fixed in position whereas the top arbors along with cartridge blocks
could be raised or lowered in vertical guides machined in housings.
Roll shafts
The roll shafts dia. 60mm will be manufactured from quality steel and will be keyed to locate tooling.
Drive
The drive to the roll former will be by means of a gear box
system and chain. The main drive will be provided by means of 10 HP
motor
Tooling
One set of Tooling with EN grade will be from imported material
suitable for your machine as standard supply. The same is involved in
operations like rough machining, keyway, rough profiling, profile
machining and inspection with final template for above.
Cutting Unit (Hydro)
Hydraulically operated power pack along with cutting die with 3 HP electrical.
- Motor-ABB
- Gear box - Elecon
- Bearing - SKF
No comments:
Post a Comment