- D coiler 1 ton cap.
- Entry Gate with
- Pipe Mill with 10 stations, 10Gear Boxes & 15 H.P. electrical.
- Control Panel semi auto
- Cutting Unit Manually
Technical Specifications
- Maximum sheet width that can be formed : 370 mm
- Maximum sheet thickness in S.S. Strips that can be formed : 2 mm
- Horizontal distance between shafts : 500mm
- Number of forming stations : 10nos.
- Vertical station : 8 nos.
- Total HP for Line : 18
- Speed of the machine : 500mm/minute
- Size of machine : 5500 x 1300 x 1100 mm
Mandrel Uncoiler
- Coil weight : 1 MT Max
- Coil width : 400 MM
- Coil bore : 470 MM min, 520 MM max dia.
- Mandrel movement : Manually
Entry Gate
Entry gate will be provided for movement of sheet to roll former.
Main Base
The main base is MS fabricated structure and adequately ribbed
to minimize the distortion. It is accurately machined on top and bottom
surfaces the threaded holes are made on the bed for positioning the
stands.
Mill stands (Station)
The stands are mounted on the bed of the machine the line
alignment can be easily done due to guide ways arranged on the bed of
the machine. Each forming head consists of a fixed housing and sliding
type out board housing. The mill stands will be arranged to locate
shafts mounted on taper bearings. For the top shafts the bearings are
housed in the cartridge type bearing blocks. The bottom shaft bearings
are located in the bored machined in the housings. The bottom arbors are
fixed in position whereas the top arbors along with cartridge blocks
could be raised or lowered in vertical guides machined in housings.
No comments:
Post a Comment